Kamerasensor NXTCam-v4: Unterschied zwischen den Versionen
Zur Navigation springen
Zur Suche springen
| Zeile 19: | Zeile 19: | ||
| Pin || Kabelfarbe ||Funktion | | Pin || Kabelfarbe ||Funktion | ||
|- | |- | ||
| 1|| weiß || | | 1|| weiß || AN | ||
|- | |- | ||
| 2|| schwarz || | | 2|| schwarz || GND | ||
|- | |- | ||
| 3|| rot || | | 3|| rot || GND | ||
|- | |- | ||
| 4 || grün || | | 4 || grün || 4,3V | ||
|- | |- | ||
| 5|| gelb || | | 5|| gelb || I²C SCL | ||
|- | |- | ||
| 6|| blau || | | 6|| blau || I²C SDA | ||
|} | |} | ||
Version vom 17. April 2025, 10:57 Uhr
| Autor: | Prof. Dr.-Ing. Schneider |
Dokumente
| Medium:Mindsensors setup.pdf | Mindstorms Setup (1 MB, EN) |
| Medium:NXTCam-v4-User-Guide.pdf | User Guide (0,6 MB, EN) |
Pinbelegung
| Pin | Kabelfarbe | Funktion |
| 1 | weiß | AN |
| 2 | schwarz | GND |
| 3 | rot | GND |
| 4 | grün | 4,3V |
| 5 | gelb | I²C SCL |
| 6 | blau | I²C SDA |
Feedback zum Anschluss an den Arduino
Dear Prof. Dr. Ulrich Schneider, you can use NxtCam with Arduino, you may need to create cable that connect cam to Arduino I2C and power (5V) pins you can us drivers and software for our EvShield GitHub repo after some small modicication.
LOP
- Programmierung
- Flashen der neuen Firmware
- Flashen der ursprünglichen Firmware
BSD-Lizenz
Copyright (c) 2014, Hochschule Hamm-Lippstadt, Dep. Lip. 1, Asaad Mohammed Al-Suleihi
Hochschule Hamm-Lippstadt. Alle Rechte vorbehalten.