Diskussion:Messaufbau mit Arduino: Gyroskop

#	Termin	Planung für die Folgewoche	Fortschritt
1	21.07.2023	Defining the requirements Creating a model for the system 3d Solidworks design and print Set up the components	The draft requirements have been done (but it will face lots of correction as we understand) We have an initial model. We have to check that model if it is errorless We remodelled the design. We took all the measurements. Now we will put it in solidworks We started designing it in solidworks
2	27.07.2023	Updating the requirements ( First we were told to do the project with Arduino, so we included Arduino in our requirements and then we were told that Arduino is only be part of the initial testing, not in the main model. So as we already added the Arduino to our design and work flow, we have to remove it. Updating the model Updating Solidworks design. The Servo holder has to be redesigned Designing all the components (servo, gyro, encoder, solid ring and other components) in the solidworks to make it a pre production model Make a baugruppe We have to include the PCB in our design (instead of Arduino)	We have the initial set of requirements. We updated the requirements. We started redesigning the initial solidworks model. We redisigned parts of the initial 3D design. Servo holder is redesigned. The components (servo, GY35, Encoder, Slip ring) are designed in Solidworks We made a Baugruppe We included PCB and excluded arduino from the design. Mr. Ebmeyer gave us further instruction. We are following them Update: Mr. Beck returned the solidworks design as there are some issues with that and can't be printed. we are redesigning those parts now.
3	03.08.2023		The fitting of the 3D printing parts are done We will now assemble all the components All the hardware construction are done The documentation (both in wiki and SVN are done) We will work on software & programming of the gyro project We tested the Servo, GY 35 and the Slip Ring. Servo is working fine with the shaft that we made. Slip Ring also has no issue. But the GY 35 is not working. We need to replace the chip. FC03 is also tested and working perfectly. It can measure the RPM of the servo
4	10.08.2023	Adding the SVN link of the code in wiki Check the reason why GY 35 not working Find what kind of System Test we can perform once the System is fully functional Update wiki Update SVN Documentation for the unit test/ component test (servo, gy 35, fc 03, slip ring) Once the system test is done then wire management (manage all the wires from and to the components) Create Bill of Material	SVN + Wiki updated Code SVN link added in Wiki BOM is calculated [Update: 14.08.2023] Our Gyro system needs a new GY 35. Apart from that all the Hardware, electronic components, software, everything is functional. Now we will make a system test. To do that we need to replace the damaged GY 35. We will source the new GY 35 [Update: 15.08.2023] New GY 35 is ordered, it will be delivered within 2 days We are making a system test for the Gyro project. (We will follow the structure of the system test from the Speed Tracker project)
5	17.08.2023