Diskussion:Messaufbau mit Arduino: Gyroskop

#	Termin	Planung für die Folgewoche	Fortschritt
1	21.07.2023	Defining the requirements Creating a model for the system 3d Solidworks design and print Set up the components	The draft requirements have been done (but it will face lots of correction as we understand) We have an initial model. We have to check that model if it is errorless We remodelled the design. We took all the measurements. Now we will put it in solidworks We started designing it in solidworks
2	27.07.2023	Updating the requirements ( First we were told to do the project with Arduino, so we included Arduino in our requirements and then we were told that Arduino is only be part of the initial testing, not in the main model. So as we already added the Arduino to our design and work flow, we have to remove it. Updating the model Updating Solidworks design. The Servo holder has to be redesigned Designing all the components (servo, gyro, encoder, solid ring and other components) in the solidworks to make it a pre production model Make a baugruppe We have to include the PCB in our design (instead of Arduino)	We have the initial set of requirements. We updated the requirements. We started redesigning the initial solidworks model. We redisigned parts of the initial 3D design. Servo holder is redesigned. The components (servo, GY35, Encoder, Slip ring) are designed in Solidworks We made a Baugruppe We included PCB and excluded arduino from the design. Mr. Ebmeyer gave us further instruction. We are following them
3	03.08.2023
4	10.08.2023
5	17.08.2023